[c-nsp] 3560g switch - tagged vlans and untagged frames

Jason Lixfeld jason at lixfeld.ca
Tue Apr 9 00:39:35 EDT 2013

Not on my switch. I just happen to have set this up today, funnily enough.  It takes untagged frames on the trunk and tags them with the native vlan.  It doesn't drop them. 


Sent from my mobile device

On 2013-04-09, at 12:30 AM, Jeff Kell <jeff-kell at utc.edu> wrote:

> On 4/9/2013 12:16 AM, Mike wrote:
>> It it helps. I do also have dot1q native vlan tagging enabled. I just
>> can't see inside of the switch and understand where my frames are
>> going. If I put it into switchport mode access, and switchport access
>> vlan 6, it all works fine and I see mac addresses in the table.
> If you enable native vlan tagging, it will drop any untagged frames.
> Jeff
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/

More information about the cisco-nsp mailing list