[c-nsp] NAt issue - two isp connections, need to nat 2nd isp for two dest addresses only

[Scott Voll]

Look into PBR.  you didn't state what your network config looks like.  you
will need to setup PBR to say if it's going X then route Y, then add your
Nat'ing accordingly.

Scott


On Thu, Apr 18, 2013 at 6:12 AM, false <jctx09 at yahoo.com> wrote:

> I have a generic nat overload statement that nats all my internal
> (192.168.1.x) traffic outbound. Works fine. I just added a second dedicated
> isp connection for voip traffic only and I need to have traffic destined
> for the two provider voip servers use the second/new ISP connection and
> perform nat using the public ip address of this new isp connection.
>
> ex:
> 192.168.1.0 -> use isp1 connection with nat outside and nat inside
> statements using standard nat overload command, except:
>
> anything destined for 5.5.5.5 and 5.5.5.6 must use the second isp
> connection and nat accordingly.
>
> How do I accomplish this? Could someone provide a config snippet? Any help
> would be greatly appreciated.
>
> Thank you,
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>