[c-nsp] Xconnect between two interface on a Cisco 6500 vs-S2T-10G

[Andrew K.]

I believe the 'connect' command should do the trick.

http://www.cisco.com/en/US/docs/ios/12_2sb/feature/guide/28sblcl.html#wp1099309

Works well using the EVCs configurations.

On 4/19/2013 10:12 AM, Nick Hilliard wrote:
> On 19/04/2013 13:51, Sander Steffann wrote:
>> Any reason why you're not using plain switchports and vlans? The 6500 is
>> a switch after all :-)
> ... for the same reason you would want an mpls p/w instead of
> point-to-point vlan for remote connectivity.  I.e. no special hacks to
> handle STP, local discovery protocols, etc; carrier state is preserved, and
> you're not chewing up l2 cam space on the networking infrastructure and
> doing mac limiting on the customer.  I have often wanted this particular
> feature to get me out of a hole.
>
> Nick
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>
>