[c-nsp] Cisco 6509 LACP

Mike Glass MGlass at lccountymt.gov
Fri Feb 8 17:02:37 EST 2013


This system is running an old sup2 so the you have to do the dot1q trunk on the port-channel, that's the only way.
I did change it to passive that was a grab when it was in active, I changed it back to active as it should work either way.
 
THanks
Mike

>>> Calin Chiorean <rain.echo at secdisk.net> 2/8/2013 2:36 PM >>>
Hello Mike,

There is something strange for me in your config.

- how did you configure it that the "switchport trunk encapsulation dot1q"
appears under PO1 interface, but not under physical ones?

- under the show output, you have Gi6/7     SA, that A specify Active, but
you did configure there passive, so something is wrong.

Cheers,
Rain

On 2/8/13 9:25 PM, "Mike Glass" <MGlass at lccountymt.gov> wrote:

>I hope somebody can help me, I am trying to configure a 6509 as the
>passive receiver from a Dell Force10 10Ge switch with 2 sfp to 2 gig
>ports on our 6509 switch, I see LACP is up on both sides but cannot pass
>traffic, I have only 2 vlans that will carry across the aggregate link
>from our vmware boxes, this is just a temp until I get a 10ge in our 6509
>chassis.
> 
>Attached is the config on both sides.
> 
>Make sense?
> 
>-------------------------------------------------------
>Cisco 6509 Config
>-------------------------------------------------------
> 
>interface GigabitEthernet6/7
> switchport
> no ip address
> spanning-tree portfast
> switchport mode trunk
> channel-protocol lacp
> channel-group 1 mode passive
>!
>interface GigabitEthernet6/8
> switchport
> no ip address
> spanning-tree portfast
> switchport mode trunk
> channel-protocol lacp
> channel-group 1 mode passive
> 
>
>interface Port-channel1
> description lacp Force10
> switchport
> switchport trunk encapsulation dot1q
> Switchport mode trunk
> no ip address
> logging event link-status
>--------------------------------------------------------
> 
>--------------------------------------------------------------------------
>---------
>show etherchannel detail
>--------------------------------------------------------------------------
>---------
> 
>                Channel-group listing:
>                -----------------------
> 
>Group: 1
>----------
>Group state = L2
>Ports: 2   Maxports = 16
>Port-channels: 1 Max Port-channels = 16
>Protocol:   LACP
>Minimum Links: 0
>                Ports in the group:
>                -------------------
>Port: Gi6/7
>------------
> 
>Port state    = Up Mstr In-Bndl
>Channel group = 1           Mode = Active      Gcchange = -
>Port-channel  = Po1         GC   =   -         Pseudo port-channel = Po1
>Port index    = 0           Load = 0x55        Protocol =   LACP
> 
>Flags:  S - Device is sending Slow LACPDUs   F - Device is sending fast
>LACPDUs.
>        A - Device is in active mode.        P - Device is in passive
>mode.
> 
>Local information:
>                            LACP port     Admin     Oper    Port
>Port
>Port      Flags   State     Priority      Key       Key     Number
>State
>Gi6/7     SA      bndl      32768         0x1       0x1     0x607
>0x3D
> 
>Partner's information:
> 
>          Partner Partner   LACP Partner  Partner   Partner  Partner
>Partner
>Port      Flags   State     Port Priority Admin Key Oper Key Port Number
>Port State
>Gi6/7     FA      bndl      32768         0x0       0x1      0xA5
>0x3F
> 
>Age of the port in the current state: 0d:00h:08m:06s
> 
>Port: Gi6/8
>------------
> 
>Port state    = Up Mstr In-Bndl
>Channel group = 1           Mode = Active      Gcchange = -
>Port-channel  = Po1         GC   =   -         Pseudo port-channel = Po1
>Port index    = 1           Load = 0xAA        Protocol =   LACP
> 
>Flags:  S - Device is sending Slow LACPDUs   F - Device is sending fast
>LACPDUs.
>        A - Device is in active mode.        P - Device is in passive
>mode.
> 
>Local information:
>                            LACP port     Admin     Oper    Port
>Port
>Port      Flags   State     Priority      Key       Key     Number
>State
>Gi6/8     SA      bndl      32768         0x1       0x1     0x608
>0x3D
> 
>Partner's information:
> 
>          Partner Partner   LACP Partner  Partner   Partner  Partner
>Partner
>Port      Flags   State     Port Priority Admin Key Oper Key Port Number
>Port State
>Gi6/8     FA      bndl      32768         0x0       0x1      0xA4
>0x3F
> 
>Age of the port in the current state: 0d:00h:08m:06s
> 
>                Port-channels in the group:
>                ----------------------
> 
>Port-channel: Po1    (Primary Aggregator)
> 
>------------
> 
>Age of the Port-channel   = 1d:01h:24m:05s
>Logical slot/port   = 14/1          Number of ports = 2
>Port state          = Port-channel Ag-Inuse
>Protocol            =   LACP
> 
>Ports in the Port-channel:
> 
>Index   Load   Port     EC state        No of bits
>------+------+------+------------------+-----------
>  0     55     Gi6/7    Active    4
>  1     AA     Gi6/8    Active    4
>--------------------------------------------------------------------------
>------
> 
> 
> 
>--------------------------------------------------------------------------
>--------------------
>Force 10 Config
>--------------------------------------------------------------------------
>--------------------
> 
>interface TenGigabitEthernet 0/24
> description LAG to VMWARE servers
> no ip address
>!
> port-channel-protocol LACP
>  port-channel 2 mode active
> no shutdown
>!
>interface TenGigabitEthernet 0/25
> description LAG to VMWARE servers
> no ip address
>!
> port-channel-protocol LACP
>  port-channel 2 mode active
> no shutdown
> 
>
>interface TenGigabitEthernet 0/34
> description LAG to Cisco 6905
> no ip address
>!
> port-channel-protocol LACP
>  port-channel 1 mode active
> no shutdown
>!
>interface TenGigabitEthernet 0/35
> description LAG to Cisco 6905
> no ip address
>!
> port-channel-protocol LACP
>  port-channel 1 mode active
> no shutdown
> 
>interface Port-channel 1
> description LAG to Cisco 6905
> no ip address
> switchport
> no shutdown
>!
>interface Port-channel 2
> description LAG to VMWARE Servers
> no ip address
> switchport
> no shutdown
>!
>interface Vlan 1
>!
>interface Vlan 2
> name VMWARE Data VLAN
> no ip address
> tagged Port-channel 1-2
> no shutdown
>!
>interface Vlan 4
> no ip address
> tagged Port-channel 1-2
> no shutdown
>---------------------------------------------------------
> 
>
>--------------------------------------------------------------
>AIS-Prod-1#sh lacp 1
>--------------------------------------------------------------
> 
>Port-channel 1 admin up, oper up, mode lacp
>Actor   System ID:  Priority 32768, Address 0001.e88b.52b8
>Partner System ID:  Priority 32768, Address 00d0.0345.8800
>Actor Admin Key 1, Oper Key 1, Partner Oper Key 1
>LACP LAG 1 is an aggregatable link
> 
>A - Active LACP, B - Passive LACP, C - Short Timeout, D - Long Timeout
>E - Aggregatable Link, F - Individual Link, G - IN_SYNC, H - OUT_OF_SYNC
>I - Collection enabled, J - Collection disabled, K - Distribution enabled
>L - Distribution disabled, M - Partner Defaulted, N - Partner
>Non-defaulted,
>O - Receiver is in expired state, P - Receiver is not in expired state
> 
>Port Te 0/34 is enabled, LACP is enabled and mode is lacp
>  Actor   Admin: State ACEHJLMP Key 1 Priority 32768
>           Oper: State ACEGIKNP Key 1 Priority 32768
>  Partner Admin: State BDFHJLMP Key 0 Priority 0
>           Oper: State ADEGIKNP Key 1 Priority 32768
> 
>Port Te 0/35 is enabled, LACP is enabled and mode is lacp
>  Actor   Admin: State ACEHJLMP Key 1 Priority 32768
>           Oper: State ACEGIKNP Key 1 Priority 32768
>  Partner Admin: State BDFHJLMP Key 0 Priority 0
>           Oper: State ADEGIKNP Key 1 Priority 32768
>---------------------------------------------------------------
> 
>------------------------------------------------------------------
>AIS-Prod-1#sh lacp 2
>------------------------------------------------------------------
>Port-channel 2 admin up, oper up, mode lacp
>Actor   System ID:  Priority 32768, Address 0001.e88b.52b8
>Partner System ID:  Priority 65535, Address ac16.2d73.1cdc
>Actor Admin Key 2, Oper Key 2, Partner Oper Key 11
>LACP LAG 2 is an aggregatable link
> 
>A - Active LACP, B - Passive LACP, C - Short Timeout, D - Long Timeout
>E - Aggregatable Link, F - Individual Link, G - IN_SYNC, H - OUT_OF_SYNC
>I - Collection enabled, J - Collection disabled, K - Distribution enabled
>L - Distribution disabled, M - Partner Defaulted, N - Partner
>Non-defaulted,
>O - Receiver is in expired state, P - Receiver is not in expired state
> 
>Port Te 0/24 is enabled, LACP is enabled and mode is lacp
>  Actor   Admin: State ACEHJLMP Key 2 Priority 32768
>           Oper: State ACEGIKNP Key 2 Priority 32768
>  Partner Admin: State BDFHJLMP Key 0 Priority 0
>           Oper: State ADEGIKNP Key 11 Priority 255
> 
>Port Te 0/25 is enabled, LACP is enabled and mode is lacp
>  Actor   Admin: State ACEHJLMP Key 2 Priority 32768
>           Oper: State ACEGIKNP Key 2 Priority 32768
>  Partner Admin: State BDFHJLMP Key 0 Priority 0
>           Oper: State ADEGIKNP Key 11 Priority 255
> 
> 
>Thanks
>Mike
> 
>_______________________________________________
>cisco-nsp mailing list  cisco-nsp at puck.nether.net
>https://puck.nether.net/mailman/listinfo/cisco-nsp
>archive at http://puck.nether.net/pipermail/cisco-nsp/





More information about the cisco-nsp mailing list