[c-nsp] me3600x tengig sfp problem

[Aaron]

weird, look what happens...

 

Feb 22 09:05:04: %PHY-4-SFP_NOT_SUPPORTED: The SFP in Te0/1 is not supported
Feb 22 09:05:04: %PM-4-ERR_DISABLE: gbic-invalid error detected on Te0/1,
putting Te0/1 in err-disable state
Feb 22 09:05:04: local_port_disable for: Te0/1 xcvr-disable failed

 

it doesn't show up in "show inventory"

 

i bounce port and it comes out of err-dsbld but it still doesn't come up

 

Feb 22 09:06:53: %LINK-5-CHANGED: Interface TenGigabitEthernet0/1, changed
state to administratively down
Feb 22 09:06:54: %SYS-5-CONFIG_I: Configured from console by vty0
(192.168.150.91)
Feb 22 09:06:55: %LINK-3-UPDOWN: Interface TenGigabitEthernet0/1, changed
state to down

 

comparing the working tengig int in 0/2... only difference is SFP-ER is not
seen on problematic one....

 

3600#sh int ten0/2 | in Trans
Transport mode LAN (10GBASE-R, 10.3125Gb/s), media type is SFP-ER



3600#sh int ten0/1 | in Trans
Transport mode LAN (10GBASE-R, 10.3125Gb/s), media type is

 

my field tech tells me that the sfp does have the cisco logo on it. (cisco
tac on the phone looking up serial number right now)

 

look what my collegue found on the internet... undoc command

 

service unsupported-transceiver
no errdisable detect cause gbic-invalid

 

but this still doesn't make it work. i tried 2 different me3600 chassis and
2 different sfp's. same result. field tech using light meter sees NO LIGHT
coming right off sfp

 

me3600x running 15.3(1)S

 

Aaron