[c-nsp] VACL and SPAN load share on destination ports

[Ben Hammadi, Kayssar (NSN - TN/Tunis)]

Dears , 

  I am trying to load balance on destination port with SPAN and VACL ,
Below the configuration :

interface GigabitEthernet9/24
switchport
switchport trunk encapsulation dot1q
switchport mode trunk
switchport nonegotiate
switchport capture
interface GigabitEthernet9/46
switchport
switchport trunk encapsulation dot1q
switchport mode trunk
switchport nonegotiate
switchport capture


monitor session 1 source vlan 1351 , 1356 - 1357 , 3737
monitor session 1 destination interface Gi1/43
monitor session 1 destination interface Gi9/23

    load balancing is needed between Gi9/24 and Gi9/46 by VACL  , and
needed between Gi1/43 and Gi9/23 by SPAN. I tried to group Gi9/24 and
Gi9/46 into a port channel but "switchport capture" was not supported
under a Po, I tried also to load balance manually by  "switchport
capture allowed vlan ..."  but I start to have one way traffic and lot
of  missing packet   : 

TSA3-PACOSWA9002(config)#interface port-channel 3
TSA3-PACOSWA9002(config-if)#switchport capture
                                       ^
% Invalid input detected at '^' marker.

Any suggestion please ?

BEN HAMMADI Kayssar
 
NOKIA SIEMENS NETWORKS
Lead Engineer -BroadBand Connectivity
JNCIE (#471), CCIP