[c-nsp] MQC on Sup-2T & WS-X6908-10G

[Alex K.]

Thank you very much.

I was looking for such document.



On Wed, Jun 5, 2013 at 5:04 PM, Michel Grossenbacher <pashtuk at gmail.com>wrote:

> Hi Alex
> Cat65k with SUP2-T does actually support configuration similar to MQC, its
> called C3PL. The issue you got is nothing card related, this is how QoS on
> the new Cat65k with SUP2T works, you cannot configure egress qos on
> Etherchannel Interfaces, it has to be done on the physical interfaces. You
> can get the Info here:
> http://www.cisco.com/en/US/docs/solutions/Enterprise/Video/qoscampuscat6500sup2taag.html#wp1053910
>
> "
> Ingress QoS policies on the Cisco Catalyst 6500 are configured on the
> logical Port-Channel interface (typically these are simply to enable DSCP
> trust, which is enabled by default on the Sup2T) , while egress QoS
> policies are configured on the physical port-member interfaces."
>
> regards
>
> Michel
>
>
> On 5 June 2013 13:05, Alex K. <nsp.lists at gmail.com> wrote:
>
>> Hello everybody,
>>
>>
>> Some interesting problem I ran into recently – MQC not supported in output
>> direction on Sup-2T & WS-X6908-10G?
>>
>> Let consider following simple configuration:
>>
>> class-map AF1X
>>  match ip dscp af11 af12 af13
>>
>> class-map AF2X
>>  match ip dscp af21 af22 af23
>>
>> policy-map TEST
>>  class AF1X
>>  class AF2X
>>
>> interface po1
>>  service-policy output TEST
>> MQC features are not supported in output direction for this interface
>>
>>
>>
>>
>> As far as I know, the following combination – 6513E + Sup-2T +
>> WS-X6908-10G
>> – does support MQC. I tried this configuration on 2 different boxes (same
>> hardware, different s/w) – same error.
>>
>> Any ideas will be appreciated.
>> _______________________________________________
>> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>>
>
>