[c-nsp] Fwd: BGP Signalled VPLS on ME3600

[Gustav.Ulander at steria.se]

Hello.

Do you have a corresponding entry in the mpls forwarding database for the 
next hop address?

Bästa hälsningar / Best regards,

Gustav Uhlander
Communication & Infrastructure Engineer

Steria AB
Kungsbron 13
Box 169
SE-101 23  Stockholm
Sweden

Tel: +46 8 622 42 15
Fax: +46 8 622 42 23
Mobile: +46 70 962 71 03
gustav.ulander at steria.se 
www.steria.se




From:   Nick Ryce <nick at fluency.net.uk>
To:     "cisco-nsp at puck.nether.net" <cisco-nsp at puck.nether.net>
Date:   2013-06-06 20:11
Subject:        [c-nsp] Fwd: BGP Signalled VPLS on ME3600
Sent by:        "cisco-nsp" <cisco-nsp-bounces at puck.nether.net>




Hi,

Im having a strange issue with a BGP signalled VPLS on my ME3600.  I'm 
running 15.3.2(s).

The VFI comes up but the virtual circuit stays down with the following 
error:-

SW1.THN-LON#show mpls L2transport vc 501 detail
Local interface: VFI FLVPLS001 vfi up
  Interworking type is Ethernet
  Destination address: 46.226.0.10, VC ID: 501, VC status: down
    Last error: MPLS dataplane reported a fault to the nexthop
    Output interface: none, imposed label stack {}
    Preferred path: not configured
    Default path: no route
    No adjacency
  Create time: 00:19:42, last status change time: 00:19:42
    Last label FSM state change time: 00:19:42
  Signaling protocol: BGP
    Status TLV support (local/remote)   : Not Applicable
      LDP route watch                   : Not Applicable
      Label/status state machine        : activating, LruRruD
      Last local dataplane   status rcvd: DOWN(pw-tx-fault)
      Last BFD dataplane     status rcvd: Not Applicable
      Last BFD peer monitor  status rcvd: Not Applicable
      Last local AC  circuit status rcvd: No fault
      Last local AC  circuit status sent: DOWN(pw-rx-fault)
      Last local PW i/f circ status rcvd: No fault
      Last local LDP TLV     status sent: Not Applicable
      Last remote LDP TLV    status rcvd: Not Applicable
      Last remote LDP ADJ    status rcvd: Not Applicable
    MPLS VC labels: local 27, remote 16
    Group ID: local 0, remote 0
    MTU: local 1500, remote 1500
  Control Word: Off
  Dataplane:
    SSM segment/switch IDs: 0/10075 (used), PWID: 12
  VC statistics:
    transit packet totals: receive 0, send 0
    transit byte totals:   receive 0, send 0
    transit packet drops:  receive 0, seq error 0, send 0



The next hop is available and routable so not quite sure what the issue 
is.  Any help greatly appreciated.

Nick


_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/