[c-nsp] Fwd: BGP Signalled VPLS on ME3600

[Nick Ryce]

Hi,

Im having a strange issue with a BGP signalled VPLS on my ME3600.  I'm running 15.3.2(s).

The VFI comes up but the virtual circuit stays down with the following error:-

SW1.THN-LON#show mpls L2transport vc 501 detail
Local interface: VFI FLVPLS001 vfi up
  Interworking type is Ethernet
  Destination address: 46.226.0.10, VC ID: 501, VC status: down
    Last error: MPLS dataplane reported a fault to the nexthop
    Output interface: none, imposed label stack {}
    Preferred path: not configured
    Default path: no route
    No adjacency
  Create time: 00:19:42, last status change time: 00:19:42
    Last label FSM state change time: 00:19:42
  Signaling protocol: BGP
    Status TLV support (local/remote)   : Not Applicable
      LDP route watch                   : Not Applicable
      Label/status state machine        : activating, LruRruD
      Last local dataplane   status rcvd: DOWN(pw-tx-fault)
      Last BFD dataplane     status rcvd: Not Applicable
      Last BFD peer monitor  status rcvd: Not Applicable
      Last local AC  circuit status rcvd: No fault
      Last local AC  circuit status sent: DOWN(pw-rx-fault)
      Last local PW i/f circ status rcvd: No fault
      Last local LDP TLV     status sent: Not Applicable
      Last remote LDP TLV    status rcvd: Not Applicable
      Last remote LDP ADJ    status rcvd: Not Applicable
    MPLS VC labels: local 27, remote 16
    Group ID: local 0, remote 0
    MTU: local 1500, remote 1500
  Control Word: Off
  Dataplane:
    SSM segment/switch IDs: 0/10075 (used), PWID: 12
  VC statistics:
    transit packet totals: receive 0, send 0
    transit byte totals:   receive 0, send 0
    transit packet drops:  receive 0, seq error 0, send 0



The next hop is available and routable so not quite sure what the issue is.  Any help greatly appreciated.

Nick