[c-nsp] Fabricpath and L3 on the same line card

[Lustgraaf, Paul J [ITNET]]

Well, I'm doing it, so I guess it can.

And F2 modules must be in a VDC by themselves, so no M1 could possibly be involved.

Paul Lustgraaf                    grpjl at iastate.edu                        "Change is inevitable.  Progress is not."
Network Engineer, Iowa State University IT Services                                                      515-294-0324


-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Chris Evans
Sent: Thursday, March 21, 2013 11:57 AM
To: cisco-nsp
Subject: [c-nsp] Fabricpath and L3 on the same line card

Can anyone tell me if Cisco F2/F2e line modules can run Fabricpath and L3
(SVI's) on the same line module. Is it line rate as well or does it proxy through an ASIC burning ports, etc. Is an M1 module required?

Someone has told me it cannot, but I believe it can. Are there any limitations with it?
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/