[c-nsp] Problems with Netflow records creation on 6513/SUP2T-10G + WS-X6716-10GE/WS-F6K-DFC4-E

[Chad Burnham]

HI Phil,

The relevant config is below and is being applied on a VLAN, it works fine with non module 12 (6716/DFC4-E) ports:

flow record inbound
 match ipv4 protocol
 match ipv4 source address
 match ipv4 destination address
 match transport source-port
 match transport destination-port
 collect counter bytes
 collect counter packets
!
flow platform cache timeout active 64
!
flow exporter safeconnect
 description safeconnect-netflow-exporter
 destination 130.253.10.1
 source Vlan10
 transport udp 50001
 export-protocol netflow-v5
!
flow monitor NetFlowmonitor
 description safeconnect-netflow-exporter
 exporter safeconnect
 record inbound

flow hardware usage notify input 75 120

interface Vlan80X
 description PIONEERNET-Private-X
 ip address 10.8.X.254 255.255.252.0
...
ip flow monitor NetFlowmonitor input
...
end

----

The other modules are not the same model/DFC - all of the other have CFC (except one):

CS-UTS-0#sho mod
Mod Ports Card Type                              Model              Serial No.
--- ----- -------------------------------------- ------------------ -----------
  3   24  CEF720 24 port 1000mb SFP              WS-X6724-SFP       SAL1135YY4H
  5   24  CEF720 24 port 1000mb SFP              WS-X6724-SFP       SAL14028CVS
  6   48  CEF720 48 port 10/100/1000mb Ethernet  WS-X6848-GE-TX     SAL1604263F
  7    5  Supervisor Engine 2T 10GE w/ CTS (Acti VS-SUP2T-10G       SAL16052XT1
  8    5  Supervisor Engine 2T 10GE w/ CTS (Hot) VS-SUP2T-10G       SAL16052XNQ
  9   48  CEF720 48 port 10/100/1000mb Ethernet  WS-X6748-GE-TX     SAL091161CM
 10    4  CEF720 4 port 10-Gigabit Ethernet      WS-X6704-10GE      SAL09116091
 11    4  CEF720 4 port 10-Gigabit Ethernet      WS-X6704-10GE      SAL09169GSB
 12   16  CEF720 16 port 10GE                    WS-X6716-10GE      SAL1310LE0A
 13    8  Network Analysis Module                WS-SVC-NAM-2       SAD074905U2

Mod  Sub-Module                  Model              Serial       Hw     Status 
---- --------------------------- ------------------ ----------- ------- -------
  3  Centralized Forwarding Card WS-F6700-CFC       SAL11370JX1  4.0    Ok
  5  Centralized Forwarding Card WS-F6700-CFC       SAL14049E3T  4.1    Ok
  6  Distributed Forwarding Card WS-F6K-DFC4-A      SAL16052XWV  1.1    Ok
  7  Policy Feature Card 4       VS-F6K-PFC4XL      SAL160211UC  1.0    Ok
  7  CPU Daughterboard           VS-F6K-MSFC5       SAL16042EKV  1.3    Ok
  8  Policy Feature Card 4       VS-F6K-PFC4XL      SAL160211VC  1.0    Ok
  8  CPU Daughterboard           VS-F6K-MSFC5       SAL16052XB9  1.3    Ok
  9  Centralized Forwarding Card WS-F6700-CFC       SAL09094U3P  2.0    Ok
 10  Centralized Forwarding Card WS-F6700-CFC       SAL091388E4  2.0    Ok
 11  Centralized Forwarding Card WS-F6700-CFC       SAL14491QCH  4.1    Ok
 12  Distributed Forwarding Card WS-F6K-DFC4-E      SAL1651UNCT  1.2    Ok

Thanks,

Chad

-----Original Message-----
From: cisco-nsp [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Phil Mayers
Sent: Monday, September 23, 2013 9:16 AM
To: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] Problems with Netflow records creation on 6513/SUP2T-10G + WS-X6716-10GE/WS-F6K-DFC4-E

On 23/09/13 15:18, Chad Burnham wrote:
>
> HI,
>
> We have an issue troubleshooting a lack of net flow records being 
> created on any traffic that is ingresses into a port on a 
> WS-X6716-10GE/WS-F6K-DFC4-E module/line card. Other line cards in this 
> chassis create netflow records just fine.

What's the relevant config? Flow exporter settings, port/vlan config, etc.?

It sounds bug-esque if other modules are generating flows ok (also 6716?) _______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/