[c-nsp] C3KX-PWR-715WAC Power supply question

Kienzle, John John.Kienzle at anadarko.com
Tue Jun 17 10:13:59 EDT 2014


In regards to the C3KX-PWR-715WAC Power supply model, the tech specs show the input voltage as -36 to -72 VDC, which is applicable to our -48 VDC, positive ground power systems at most of our tower locations. However I have one location that has a +48 volt power supply system. Am I able to power the power supply with +48 volts as long as negative is connected to negative and positive to positive? We have done that in the past with +48VDC devices where we tie them to the -48v system, and because the grounds are isolated we can reverse the polarity with no problems. I am wondering if I can do that in this situation. Otherwise I will convert it to a -48VDC power supply system like the rest of my tower locations.

Thanks.

John Kienzle





Click here for Anadarko’s Electronic Mail Disclaimer<http://www.anadarko.com/notices/Pages/Electronic-Mail-Disclaimer.aspx>


More information about the cisco-nsp mailing list