[c-nsp] first post: SA-VAM2 question

[Dave McGuire]

On 10/21/2014 02:34 PM, Rob Seastrom wrote:
>>   Hey folks, new listmember here.  Greetings to everyone; I'm sure I'll
>> see some familiar names here.
>>
>>   I'm wondering if someone can clear something up for me.  I have a
>> 7206VXR with an NPE-G1 with 1GB of RAM, running
>> "c7200-adventerprisek9-mz.151-4.M2.bin".  I am doing some IPsec tunnels
>> and everything works great.
>>
>>   I picked up an SA-VAM2 module recently, which from everything I can
>> find should function in this configuration.  However, "sh diag" reports
>> this module as "disabled unsuitable deactivated powered off".  As
>> evidenced by the module's LEDs at boot time, it powers up momentarily
>> and then powers down.
>>
>>   I think it ought to be working; I'm guessing I've missed something.
>> Possibly something rather stupid. ;)  Can anyone point me in the right
>> direction?  I appreciate any advice from the collective sage wisdom of
>> cisco-nsp.
> 
> Have you tried feature navigator?  I see documentation that an SA-VAM2
> should work with an NPE-G1, but the "Last Date of Support" for that
> board was April 29, 2011...  I would not be too sanguine about support
> for it at all in 15.1.

  Hey there Rob, I'm not at all surprised to see you here. :)

  You are correct.  I picked up an SA-VAM2+ to replace it, and it's in
service and working great.

               Thanks,
               -Dave

-- 
Dave McGuire, AK4HZ/3
New Kensington, PA