[c-nsp] MPLS router-ID

James Bensley jwbensley at gmail.com
Mon Aug 24 04:01:48 EDT 2015

On 12 August 2015 at 10:01, Mohammad Khalil <eng_mssk at hotmail.com> wrote:
> interface FastEthernet1/0
>  mpls ip
>  mpls ldp discovery transport-address
>  mpls bgp forwarding


> interface Loopback0
>  ip address
> interface Loopback1
>  ip address

Mohammad, I think you have missed something here. There is a gap in
your knowledge, you should remove the config and start again. I'm not
sure why you would have "mpls ip" and "mpls bgp forwarding" configured
on the same interface? Nor why you would have two loopsbacks? You're
provider shouldn't need connectivity to either, since this is eBGP
based inter-as MPLS.


More information about the cisco-nsp mailing list