[c-nsp] ASR903 dir Error

[Robert Blayzor]

> On Mar 18, 2015, at 3:16 AM, Mohammad Khalil <eng_mssk at hotmail.com> wrote:
> 
> I have Cisco ASR 903 with two RSPs
> When I console to one for the RSPs , i am in the rommon mode
> When I try to browse for the bootflash , I get the below message
> rommon 1 > dir bootflash:
> 
> ERROR:: PRSSTAT.BREN is NOT set. Data xfr incomplete
> 
> FAILURE
> prsstat ff8d0206 not ESDHC_PRSSTAT_BREN i= 
> 0esdhc_wait_for_status_clr(556) ERR: bitmask=0x00000002 not clr PRSSTAT =
> 0xff8d0206 i=100000
> sd_read_sector(1464) failed
> Disk Error : Unable to read the drive'spartition table
> 
> From the other RSP , when I issue the show platform command , the same RSP show as unknown


I had this problem shortly at after FCS on early versions of XE. Make sure you have the latest boot rom, but if you're at this point it's probably to late. I had to end up RMA swapping the RSP. 

--
Robert
inoc.net!rblayzor
http://inoc.net/