[c-nsp] AToM

[Craig Whitmore]

What's the mtu of the 2 vlans? I always set the mtu in the xconnect stanza.

Sent from my iPhone

> On 24/03/2015, at 8:49 pm, Mohammad Khalil <eng_mssk at hotmail.com> wrote:
> 
> Hi all
> I am trying to establish AToM between 7613 and 3600
> The module from the 7613 side is 7600 ES+ 20xGE SFP 
> 
> 3600#sh run int vlan 183
> interface Vlan183
> no ip address
> xconnect 172.20.40.7 7232183 encapsulation mpls
> 
> 7613#sh run int vlan 183
> interface Vlan183
> no ip address
> load-interval 30
> xconnect 172.20.40.232 7232183 encapsulation mpls
> 
> 7613#sh mpls l2transport vc 7232183
> 
> Local intf     Local circuit              Dest address    VC ID      Status    
> -------------  -------------------------- --------------- ---------- ----------
> Vl183          Eth VLAN 183               172.20.40.232   7232183    UP
> 
> 3600#sh mpls l2transport vc 7232183
> 
> Local intf     Local circuit              Dest address    VC ID      Status
> -------------  -------------------------- --------------- ---------- ----------
> Vl183          Eth VLAN 183               172.20.40.7     7232183    DOWN 
> 
> I have tried to configure L3VPN (VRF on both routers and test loopback interfaces) and it worked fine 
> 
> Any ideas?
> 
> BR,
> Mohammad
>                         
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/