[c-nsp] 7600 67xx DOM support

Mack McBride mack.mcbride at viawest.com
Fri Jun 24 14:59:33 EDT 2016

The 10G blades (67xx) support it in 7600 code and 6500 code.
The following link indicates it works on the SFP blades but no idea
On code rev. or hardware required:


>From a 10G module:

#sh int transceiver mod 1
Transceiver monitoring is disabled for all interfaces.

If device is externally calibrated, only calibrated values are printed.
++ : high alarm, +  : high warning, -  : low warning, -- : low alarm.
NA or N/A: not applicable, Tx: transmit, Rx: receive.
mA: milliamperes, dBm: decibels (milliwatts).

                                           Optical   Optical
           Temperature  Voltage  Current   Tx Power  Rx Power
Port       (Celsius)    (Volts)  (mA)      (dBm)     (dBm)
---------  -----------  -------  --------  --------  --------
Te1/2        28.5       0.00       6.9      -2.6      -3.3
Te1/4        29.3       0.00      37.8      -2.3      -2.1
Te1/5        29.4       0.00       6.0      -2.7      -2.6
Te1/6        27.2       0.00       5.9      -2.7      -2.1

Mack McBride | Senior Network Architect | ViaWest, Inc.
O: 720.891.2502 | C: 303.720.2711 | mack.mcbride at viawest.com | www.viawest.com

-----Original Message-----
From: cisco-nsp [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Nick Hilliard
Sent: Wednesday, June 22, 2016 1:37 PM
To: Jason Lixfeld
Cc: Cisco Network Service Providers
Subject: Re: [c-nsp] 7600 67xx DOM support

Jason Lixfeld wrote:
> Is the lack of DOM on 67xx series 7600 cards still a thing?

there was a brief period around SXF4 to SXF11 or so where it worked on hw 3.0 cards.  Other than that, it was disabled in software.

cisco-nsp mailing list  cisco-nsp at puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
This message contains information that may be confidential, privileged or otherwise protected by law from disclosure. It is intended for the exclusive use of the addressee(s). Unless you are the addressee or authorized agent of the addressee, you may not review, copy, distribute or disclose to anyone the message or any information contained within. If you have received this message in error, please contact the sender by electronic reply and immediately delete all copies of the message.

More information about the cisco-nsp mailing list