[c-nsp] ISR4431 integrated "POE" ports

[CiscoNSP List]

Cheers Octavio - I understand only 4 ports can be used simultaneously….but the RJ45 ports would not work(Got links, but no layer2/3)…inserted SFPs in the other 4ports, disconnected the RJ45 ports, and all works fine.

Another list member suggested it could be due to the "new" failover features…i.e. the RJ45's you need to configure as the primary interfaces….Ill need to look into this further…but as it stands atm, SFP's work in the 4 ports without issue, changing to the RJ45's, we get links, but can't pass traffic.



________________________________________
From: Octavio Alvarez <octalcnsp at alvarezp.org>
Sent: Wednesday, 11 May 2016 5:22 PM
To: CiscoNSP List
Cc: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] ISR4431 integrated "POE" ports

On 05/10/2016 05:24 PM, CiscoNSP List wrote:
>
> Thanks Nathan - The device has 8 ports as per the doc here:
>
> http://www.cisco.com/c/en/us/td/docs/routers/access/4400/hardware/installation/guide4400-4300/C4400_isr/Overview.html#32890

It's 4 dual-port interfaces, not 8 interfaces. You can use the SFP *or*
RJ-45 port for that interface (you choose using "media-type" in
interface config mode) but it's only one interface.

Ports 0 and 1 (only on RJ-45) can additionally be set as PoE if certain
conditions are met.

So you can not use the two ports of the same interface simultaneously.

Best regards.