[c-nsp] ASR1006 RP2 8G vs 16G memory

[Mark Tinka]

On 19/May/16 16:04, Lukas Tribus wrote:

> 8 GB RAM would be enough even if you had a full BGP table.

We just max. it out and forget about it.

That said, a 16GB RP will report 8G for use. See below:

cisco ASR1006 (RP2) processor (revision RP2) with *9877599K/6147K* bytes
of memory.
Processor board ID FXS1813Q21G
2 Ten Gigabit Ethernet interfaces
32768K bytes of non-volatile configuration memory.
*16777216K* bytes of physical memory.
1884159K bytes of eUSB flash at bootflash:.
78085207K bytes of SATA hard disk at harddisk:.
15856K bytes of obfl at obfl:.

Configuration register is 0x2102

Mark.