[c-nsp] ASR920 stops routing unexpectedly

[Spyros Kakaroukas]

Thank you all for the responses.

Does the workaround (platform acl egress-disable ) actually require a reload
? I did apply it on a box without a reload, since it didn't ask for one, and
I had the issue occur again a few hours later.




My thoughts and words are my own.

Kind Regards,

Spyros


-----Original Message-----
From: Mark Tinka [mailto:mark.tinka at seacom.mu] 
Sent: Thursday, May 19, 2016 11:02 PM
To: Jason Lixfeld <jason at lixfeld.ca>
Cc: Spyros Kakaroukas <s.kakaroukas at connecticore.com>; CiscoNSP List
<CiscoNSP_list at hotmail.com>; Eric Van Tol <eric at atlantech.net>;
cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] ASR920 stops routing unexpectedly



On 19/May/16 19:11, Jason Lixfeld wrote:

>
> Interesting.  We had no IPv6 ACLs.  Our only recourse was either disable
(ipv4) egress ACLs or disable IPv6..

Cisco did mention that the issue is present with both IPv4 and IPv6 ACL's,
or with just IPv4 ACL's.

The issue also presents itself if MPLS is enabled, together with IPv6
routing.

Mark.