[c-nsp] ASR920 stops routing unexpectedly

[Mark Tinka]

AFAIK, a reload is not required.

We applied it without a reload and we haven't had an issue since. We are
on 15.5(3)S2, if it matters.

Mark.

On 20/May/16 07:22, Spyros Kakaroukas wrote:
> Thank you all for the responses.
>
> Does the workaround (platform acl egress-disable ) actually require a reload
> ? I did apply it on a box without a reload, since it didn't ask for one, and
> I had the issue occur again a few hours later.
>
>
>
>
> My thoughts and words are my own.
>
> Kind Regards,
>
> Spyros
>
>
> -----Original Message-----
> From: Mark Tinka [mailto:mark.tinka at seacom.mu] 
> Sent: Thursday, May 19, 2016 11:02 PM
> To: Jason Lixfeld <jason at lixfeld.ca>
> Cc: Spyros Kakaroukas <s.kakaroukas at connecticore.com>; CiscoNSP List
> <CiscoNSP_list at hotmail.com>; Eric Van Tol <eric at atlantech.net>;
> cisco-nsp at puck.nether.net
> Subject: Re: [c-nsp] ASR920 stops routing unexpectedly
>
>
>
> On 19/May/16 19:11, Jason Lixfeld wrote:
>
>> Interesting.  We had no IPv6 ACLs.  Our only recourse was either disable
> (ipv4) egress ACLs or disable IPv6..
>
> Cisco did mention that the issue is present with both IPv4 and IPv6 ACL's,
> or with just IPv4 ACL's.
>
> The issue also presents itself if MPLS is enabled, together with IPv6
> routing.
>
> Mark.
>
>