[c-nsp] IOS XR and MPLSoMGRE

[mihai at duras.ro]

Hi Arie,

That's what I also stumbled upon but I noticed it says that MPLSoMGRE 
should be supported but then I only spot p2p Tunnel interfaces and I'm 
not sure if some small detail escapes my site or how I can configure a 
multipoint tunnel interface:)
That would be step one and step 2 figuring out the route-map equivalent 
that would then build a tunnel to the nexthop received as it was the 
case with IOS XE.

Have a feeling that I will get some headaches along the way..this is not 
really a very detailed/documented topic.

On 2018-05-17 00:02, Arie Vayner wrote:
> Mihai,
> 
> Try checking this document:
> https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k_r6-1/lxvpn/configuration/guide/b-l3vpn-cg-asr9k-61x/b-l3vpn-cg60xasr9k_chapter_0100.pdf
> 
> I have a feeling this will require a bit trial and error, but this
> seems to be the right direction.
> 
> On Wed, May 16, 2018 at 2:57 PM <mihai at duras.ro> wrote:
> 
>> Hi guys,
>> 
>> I'm trying something strange and funky in a lab and of course ending
>> up
>> at a dead-end :)
>> 
>> I'm trying to configure OpenContrail to peer with ASR9K.
>> I've already found a sample configuration for ASR903 but that one
>> has
>> IOS XE.
>> 
>> Does anyone know if there is an equivalent for the following
>> commands on
>> IOS XR?
>> So far I can't find anything and am knocking my head against the
>> wall a
>> bit (I did find that MGRE should be supported though and MPLS over
>> it).
>> 
>> l3vpn encapsulation ip MGRE
>> transport ipv4 source GigabitEthernet0/4/7
>> 
>> route-map SELECT_UPDATE_FOR_L3VPN permit 10
>> set ip next-hop encapsulate l3vpn MGRE
>> 
>> Thanks in advance,
>> Mihai
>> _______________________________________________
>> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/