[c-nsp] Correct syntax for Boot system

[Tyler Applebaum]

On the 4k series I use bootflash:<filename>

-----Original Message-----
From: cisco-nsp [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Scott Voll
Sent: Thursday, February 28, 2019 9:40 AM
To: cisco-nsp <cisco-nsp at puck.nether.net>
Subject: [c-nsp] Correct syntax for Boot system

I have always used

boot system flash:xxxxxx.bin or boot system bootflash:xxxx.bin

did the syntax change to boot system flash flash0:xxxxx.bin???

I have a new 4331 that without the extra flash it failed to boot.   Is this
new?  did I miss the memo?

does this carry over to ASRs and the older 29xx/39xx platforms?

I'm booting a bunch of remote routers and don't want to be driving to recover them from a simple mistake I missed.

TIA

Scott
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
Attention: Information contained in this message and or attachments is intended only for the recipient(s) named above and may contain confidential and or privileged material that is protected under State or Federal law. If you are not the intended recipient, any disclosure, copying, distribution or action taken on it is prohibited. If you believe you have received this email in error, please contact the sender with a copy to compliance at ochin.org, delete this email and destroy all copies.