[c-nsp] NAT on ASR920 Everest

Scott Miller fordlove at gmail.com
Wed Oct 21 15:11:33 EDT 2020


Hello all, I'm trying to configure NAT on an ASR920
running 16.06.05a [Everest]
GW-01#show license
Index 1 Feature: advancedmetroipaccess
        Period left: Life time
        License Type: Permanent
        License State: Active, In Use
        License Count: Non-Counted
        License Priority: Medium

Docs say it should be configurable.

https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipaddr_nat/configuration/xe-16-6/nat-xe-16-6-book.pdf

However, none of the standard NAT commands are available.
Example:ip nat inside source list 150 interface GigabitEthernet0/0/4
overload (access-list is already configured)

"nat" is not a subcommand of "ip" and I get an error:
GW-01(config)#ip nat inside source list 150 interface GigabitEthernet0/0/4
overload
                 ^
% Invalid input detected at '^' marker.

GW-01(config)#

Even under the interface, the ip nat inside or ip nat outside is not a
valid command.

LTE-NAT-HOC-GW-01(config)#ip ?
Global IP configuration subcommands:
...
...
  multicast             Global IP Multicast Commands
  multicast-routing     Enable IP multicast forwarding
  name-server           Specify address of name server to use
  nbar                  NBAR - Network Based Application Recognition
  options               IP Options treatment
...
...

Anyone know if maybe it's a license level and I need to drop
to metroipaccess or lower?  Or is EVEREST not correctly supported?

Reaching out in case anyone has run into this before.

Thanks,


More information about the cisco-nsp mailing list