[c-nsp] policer on ASR1001X

[james list]

Thanks
I would try to apply both Bps OR pps if possible

Cheers

Il Mer 8 Set 2021, 15:51 Lukasz Bromirski <lukasz at bromirski.net> ha scritto:

> Saku is always on point ;)
>
> > On 8 Sep 2021, at 15:31, Saku Ytti <saku at ytti.fi> wrote:
> >
> > On Wed, 8 Sept 2021 at 16:30, Lukasz Bromirski <lukasz at bromirski.net>
> wrote:
> >
> >>> 3) is there any mode to limit pps and not only bandwidth
> >>
> >> I no longer remember this from top of my mind, but there’s bunch of
> good QoS/HQoS presentations about ASR 1000 in particular on ciscolive.com
> that you can use as reference.
> >
> > police rate x pps
>
> Just checked this on 17.x based release (3k = 3000 for this example):
>
> rtr-edge(config-pmap-c)#police rate 3k ?
>   account         Overhead Accounting
>   bps             Treat 'rate' value in bits-per-second
>   burst           Specify 'burst' parameter
>   conform-action  action when rate is less than conform burst
>   cps             Treat 'rate' value in cells-per-second
>   peak-rate       Specify peak rate or PCR for single-level ATM 4.0
> policer policies
>   pps             Treat 'rate' value in packets-per-second
>   <cr>            <cr>
>
> --
> ./