[c-ubr] uBR7246VXR - RJ45

[Jaquish, Bret]

If it is stuck in "boot" mode, then the router is "halfway booted"

Here is what you need to do:

Verify the "boot helper image" matches with the main IOS image:

Show bootflash:
Show disk0: (or whatever disk you have the image on)

For example:

Show bootflash: shows a XD image
Show disk0: shows a "T" train image
They would be incompatible.

This document is pretty good at explaining the images.

The bootflash image needs to be the right version to support all of the interface modules (PA) installed in the chassis.

http://www.cisco.com/en/US/docs/routers/7200/install_and_upgrade/network_process_engine_install_config/npense.html

Hope this helps,

Bret


From: cisco-ubr-bounces at puck.nether.net [mailto:cisco-ubr-bounces at puck.nether.net] On Behalf Of LeeRNorman1 at aol.com
Sent: Sunday, November 01, 2009 1:15 PM
To: cisco-ubr at puck.nether.net
Subject: [c-ubr] uBR7246VXR - RJ45

Greetings from the Dallas area -

I have a uBR7246VXR with a  uBR7200-I/O-FE  (I/O Controller) that I can't get up & running.

1.  The RJ45-jack does not respond, nor does the LED beside it.  When I go into "Config Terminal" mode to assign the media-type as RJ45, I get a error.  But it will stay in MII (media-type) mode.

2.  The uBR7246VXR boots up in  "boot-mode".  It's stuck in boot-mode.  I've done the "confreg" thing, doesn't work.  How do I format a flash-disk if it won't recognize the slot &/or disk?

Best Regards,

Lee R. Norman.
972-736-3380 - hm-ofc.
508-527-0370 - mobile
972-767-3740 - fax
LeeRNorman1 at aol.com<http://mail/>

________________________________
Disclaimer Confidentiality Notice: This e-mail, and any attachments
and/or documents linked to this email, are intended for the
addressee and may contain information that is privileged,
confidential, proprietary, or otherwise protected by law. Any
dissemination, distribution, or copying is prohibited. This
notice serves as a confidentiality marking for the purpose of
any confidentiality or nondisclosure agreement. If you have
received this communication in error, please contact the
original sender.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-ubr/attachments/20091102/583124db/attachment.html>