[cisco-voip] CMM 6 Pri's

[Voll, Scott]

Currently I have a configuration of 3 PRI's going into our PBX and one
PRI from the PBX to My IPT network.  Due to the qsig signaling we have
to run this PRI as a H323 Gateway.

We have just purchased a CMM and PRI card for our 6509, and would like
to put my IPT network in front of the PBX.  Looking like 3 PRI's coming
in on the CMM (MGCP) then three PRI's going into the PBX (h323). 

So the question; with this setup do I just make a Dial peer that says
XXXX go to PBX?  CM will route any extensions it knows about (closest
match routing) to the IPT network and route the rest to the PBX?  

TIA

Scott