[cisco-voip] callmanager 4.x to avaya using qsig t1 mgcp

[Walenta, Phil]

When you refer to DTMF not cutting through, are you referring to passing
active DTMF digits to a connected device through the PBX (such as an IVR
etc)?  If this is the case, this sounds like the correct DTMF-relay
settings aren't selected for MGCP on the gateway, or possibly the
package isn't selected.  Check "mgcp dtmf-relay" and "mgcp
package-capability" in your config on that router. 

-----Original Message-----
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of
michaelreilly at nc.rr.com
Sent: Tuesday, November 09, 2004 2:47 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] callmanager 4.x to avaya using qsig t1 mgcp

I have set up a 3745 gateway to use t1 qsig with an avaya definity g3,i
am able to get the gateway to register and get dial tone. I do a show
voice call active on the gateway and see the call up, but it looks like
my dtmf is not cutting through, when I try to dial out nothing happens.
Any ideas?

Thanks,
Mike

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip