[cisco-voip] Adding Dial Peer

[chris donnelly]

Yep, I agree - either memory or dial peer already exists....

That's a hell of a lot of dial-peers....

-----Original Message-----
From: Walenta, Phil [mailto:philip.walenta at berbee.com] 
Sent: 15 October 2004 15:16
To: Voll, Scott; cisco-voip at puck.nether.net
Subject: RE: [cisco-voip] Adding Dial Peer

The last time I remember seeing this message, it was due to the router
being out of memory.  It's a good bet, that with 103 dial peers, that's
what you're running into.

________________________________

From: cisco-voip-bounces at puck.nether.net on behalf of Voll, Scott
Sent: Fri 10/15/2004 9:05 AM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] Adding Dial Peer



Has anyone else seen this problem?

PBX-VoIP(config)#dial-peer voice 10 pots
ERROR: could not add peer

When I try to add a dail peer I get error above.  I currently am using a
2621 running Ver. 12.3(10).

Is there a max dial peer?  I currently only have 103 dial peers.

Any ideas?

Scott


_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip



_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

_____________________________________________________________________
This message has been checked for all known viruses by the MessageLabs
Virus Control Centre.