[cisco-voip] h323 gateway with 2811 without gatekeeper?

[riki]

Hello Steven,

thanks for response

i used simillar setup but it ends like this:

Apr 18 19:27:07 voip 1345:    Dial String=00123456789101, Expanded 
String=00123456789101, Calling Number=
Apr 18 19:27:07 voip 1346:    Timeout=FALSE, Is Incoming=FALSE, Peer 
InfoType=DIALPEER_INFO_SPEECH
Apr 18 19:27:07 voip 1347: Apr 18 18:27:06.504 MET: 
//-1/0220C45E0BC8/DPM/MatchNextPeer:
Apr 18 19:27:07 voip 1348:    Result=MORE_DIGITS_NEEDED(1); Outgoing 
Dial-peer=2101
Apr 18 19:27:07 voip 1349: Apr 18 18:27:06.504 MET: 
//-1/0220C45E0BC8/DPM/dpMatchCore:
Apr 18 19:27:07 voip 1350:    Result=1
Apr 18 19:27:07 voip 1351: Apr 18 18:27:06.504 MET: 
//-1/0220C45E0BC8/DPM/dpMatchPeersCore:
Apr 18 19:27:07 voip 1352:    Result=Partial Matches(1) after DP_MATCH_DEST
Apr 18 19:27:07 voip 1353: Apr 18 18:27:06.504 MET: 
//-1/0220C45E0BC8/DPM/dpMatchPeersMoreArg:
Apr 18 19:27:07 voip 1354:    Result=MORE_DIGITS_NEEDED(1)

relevant configuration:

controller E1 0/0/0
  pri-group timeslots 1-31

interface Serial0/0/0:15
  no ip address
  isdn switch-type primary-net5
  isdn incoming-voice voice
  no cdp enable

voice-card 0
  no dspfarm

have you any idea what can cause the problem?

r.

Steven E. Ames wrote:
> That should be very doable. I think you can do it with one dial-peer even:
> 
> dial-peer voice 2101 pots
>  description Incoming VoIP calls
>  huntstop
>  preference 1
>  application session
>  destination-pattern T
>  direct-inward-dial
>   port 1/0:23
> !
> 
> And it should just work. (This is T1 config but it does work).
> 
> -Steve
> 
> 
>>-----Original Message-----
>>From: cisco-voip-bounces at puck.nether.net
>>[mailto:cisco-voip-bounces at puck.nether.net]On Behalf Of riki
>>Sent: Monday, April 18, 2005 12:03 PM
>>To: cisco-voip at puck.nether.net
>>Subject: [cisco-voip] h323 gateway with 2811 without gatekeeper?
>>
>>
>>Hello,
>>
>>i have cisco 2811 with 2800 Software 
>>(C2800NM-SPSERVICESK9-M), Version 
>>12.3(8)T6, RELEASE SOFTWARE (fc2) with VWIC-1MFT-E1 and 2x PVDM16
>>
>>I want to accept incoming h323 call and translate it into 
>>outgoing call 
>>on one of 31 channels on E1 interface
>>
>>Is it possible to do this without gatekeeper, because i found only 
>>setups with gk. If yes, can you provide me some links on this topic?
>>
>>Thanks for a response
>>
>>r.
>>_______________________________________________
>>cisco-voip mailing list
>>cisco-voip at puck.nether.net
>>https://puck.nether.net/mailman/listinfo/cisco-voip
>>