[cisco-voip] CallManager 4.1 and ACT Card on CMM Module
Voll, Scott
Scott.Voll at wesd.org
Tue Dec 13 15:18:57 EST 2005
More of a neat thing but why is your FE configured as half-duplex?
What is IPVM? Why not try the meetme conferencing?
Why are you having to transcode with this conference resource?
Have you thought about upgrading to xy6. It has been very stable for
us.
Scott
-----Original Message-----
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Jose Mujica
Sent: Tuesday, December 13, 2005 11:09 AM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] CallManager 4.1 and ACT Card on CMM Module
Hi.
I'm having a problem and would like your inputs. I have an ACT Module
in a
Cat6k CMM Module running 12.3(8)XY2. I have configured the mediacard for
conference resources for G711 and G729 codecs. I have also configured
the SCCP
and DSPFARM for the conference resources and associate all the
configuration
all together.
On the CCM I have created a hardware conference resource using the IOS
Enhanced Conference Resource and the device shows up as register on
callmanager and connected on the CMM Module. The client currently has a
central site and a remote site and regions has been configured to use
G729
over the WAN. The CMM module is at the central site. When a conference
bridge
is initiated using the ACT dsps I don't have 2-way voice on all 3 IP
Phones (2
central site and 1 at the remote site). On the CAT6k I can see the
sessions
with the show mediacard connected command but I only have 1-way audio.
Any ideas? Below is the config for the ACT card and show commands:
-------------
6509-CMM-GWY1#sh ver
Cisco IOS Software, Cat6K-lc Software (wscmm-I6S-M), Version 12.3(8)XY2,
RELEASE
SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2004 by Cisco Systems, Inc.
Compiled Tue 16-Nov-04 12:19 by cmong
ROM: System Bootstrap, Version 12.2(1r)T2, RELEASE SOFTWARE (fc1)
6509-CMM-GWY1 uptime is 10 weeks, 4 days, 59 minutes
System returned to ROM by power-on
System restarted at 11:41:30 AST Fri Sep 30 2005
System image file is "bootflash:wscmm-i6s-mz.123-8.XY2.bin"
cisco WS-SVC-CMM Cat6k Voice Linecard (R7000) processor (revision 0xFF)
with 196
608K/65536K bytes of memory.
Processor board ID SAD09010E57
R7000 CPU at 400MHz, Implementation 39, Rev 3.3, 256KB L2 Cache
Last reset from power-on
2 FastEthernet interfaces
1 Gigabit Ethernet interface
96 Serial interfaces
6 Channelized T1/PRI ports
32768K bytes of processor board bootflash (Read/Write)
Configuration register is 0x2102
6509-CMM-GWY1#
Total: 0
6509-CMM-GWY1#
6509-CMM-GWY1#sh mediacard connections
Id Type Slot/ RPort SPort RxPkts TxPkts Remote-Ip
DSP/Ch
1 xcode 4/1/1 19482 22392 203 0 172.16.56.34
2 xcode 4/1/2 31390 23256 198 0 172.16.55.12
Total: 2
6509-CMM-GWY1#
6509-CMM-GWY1#sh sccp conn
6509-CMM-GWY1#sh sccp connections
sess_id conn_id stype mode codec ripaddr rport sport
33560307 36347521 xcode sendrecv g711u 172.16.55.12 31390 23256
33560307 36347489 xcode sendrecv g729b 172.16.56.34 19482 22392
Total number of active session(s) 1, and connection(s) 2
6509-CMM-GWY1#
The IP Address 172.16.56.34 is the IP Phone across the WAN and the
172.16.55.12 is the IP Address of the CallManager. I'm using the IPVM
service
for conference right now and using the ACT for transcoding. The
conference was
initiated by the remote ip phone and 2 IP Phones from the central site
were in
the conference. They were able to talk to each other but i was unable to
hear
them and viceversa. I also tried to configured the ACT for conference
resources but when I initate the conference from the remote ip phone I
received a fast busy signal.
Here is the relevant config on the CMM for the ACT card:
----------------
interface GigabitEthernet1/0
ip address 172.16.57.5 255.255.255.0
no ip redirects
no ip unreachables
no ip proxy-arp
no negotiation auto
no keepalive
!
interface FastEthernet3/0
description ** Ad-hoc Confr and Tcoding PA Mod 4 **
ip address 172.16.57.10 255.255.255.255
no ip redirects
no ip unreachables
no ip proxy-arp
half-duplex
!
mediacard 4
resource-pool cfb dsps 4
!
!
sccp local GigabitEthernet1/0
sccp ccm 172.16.55.12 identifier 2 version 4.1
sccp ccm 172.16.55.11 identifier 1 version 4.1
sccp
!
sccp ccm group 1
associate ccm 2 priority 1
associate ccm 1 priority 2
associate profile 10 register CFB00033235c614
!
dspfarm
!
!
dspfarm profile 10 conference adhoc
codec g711ulaw packetization-period 30
codec g711alaw packetization-period 30
codec g729r8 packetization-period 30
codec g729ar8 packetization-period 30
codec g723r63 packetization-period 30
codec g723r53 packetization-period 30
associate resource-pool cfb
!
!
Thanks in advanced,
-Jose
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip
More information about the cisco-voip
mailing list