[cisco-voip] CFwAll error through Q.SIG

[Nick Kassel]

check out the document

 

http://www.cisco.com/warp/public/129/isdn_disc_code.html 

 

Cause i = 0x80E2 - Message not compatible with call state or not
implemented

 

 

E2

Message not compatible with call state or not implemented 

The remote equipment receives an invalid message with no standard cause.

This cause indicates that the equipment receives a message that is not
permissible in the call state according to the procedures. This cause
can also indicate that the equipment receives a STATUS message to
indicate an incompatible call state.

The issue occurs due to a D-channel error. If the error recurs, report
the error to your ISDN service provider.

 

 

 

 

 

 

 

 

 

 

 

________________________________

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Ruben Montes
Sent: Thursday, December 15, 2005 10:16 AM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] CFwAll error through Q.SIG

 

Hello,

I have a QSIG connection between a PBX MD110 and a C2851 MGCP gateway
(CCM4.1(3) cluster).

I have ip phone A (DN 48810) forwarded to ip phone B through CfwAll
softkey (DN 8001). If I try to call the number of phone A from an analog
phone that is in the PBX side, call should be forwarded to phone B.

The problem is that the call is forwarded but it only rings in phone B
during 0,5 seconds and then the call is hung. 

If I do a 'debug isdn q931' in the router I have this message:

   Sending Complete
        Bearer Capability i = 0x8090A3
                Standard = CCITT
                Transfer Capability = Speech
                Transfer Mode = Circuit
                Transfer Rate = 64 kbit/s
        Channel ID i = 0xA18396
                Preferred, Channel 22
        Progress Ind i = 0xA190 - Reserved value
        Calling Party Number i = 0x0181, '659457184'
                Plan:ISDN, Type:Unknown
        Called Party Number i = 0xC9, '48810'
                Plan:Private, Type:Subscriber(local)
        User-User i = 0x00FE, 'U', 0x0100, 'Y', 0x0100B4
        Shift to Codeset 5
        Codeset 5 IE 0x31  i = 0x81
        Shift to Codeset 5
        Codeset 5 IE 0x32  i = 0x80
Dec 15 11:09:15: ISDN Se0/0/1:15 Q931: TX -> CALL_PROC pd = 8  callref =
0xABBE

        Channel ID i = 0xA98396
                Exclusive, Channel 22
Dec 15 11:09:15: ISDN Se0/0/1:15 Q931: TX -> FACILITY pd = 8  callref =
0xABBE
        Facility i =
0x9FAA068001008201008B0100A114020101020114300C0A01010A0102800438303031
Dec 15 11:09:15: ISDN Se0/0/1:15 Q931: TX -> ALERTING pd = 8  callref =
0xABBE
        Progress Ind i = 0x8088 - In-band info or appropriate now
available
Dec 15 11:09:15: ISDN Se0/0/1:15 Q931: RX <- STATUS pd = 8  callref =
0x2BBE
        Cause i = 0x81E41C - Invalid information element contents
        Call State i = 0x03
Dec 15 11:09:15: ISDN Se0/0/1:15 Q931: TX -> DISCONNECT pd = 8  callref
= 0xABBE

        Cause i = 0x80E2 - Message not compatible with call state or not
implemented
Dec 15 11:09:15: ISDN Se0/0/1:15 Q931: RX <- RELEASE pd = 8  callref =
0x2BBE
        Cause i = 0x81E2 - Message not compatible with call state or not
implemented
        User-User i = 0x00FEB4110180
Dec 15 11:09:15: ISDN Se0/0/1:15 Q931: TX -> RELEASE_COMP pd = 8
callref = 0xABBE

Does anybody know which is the problem?

Thanks in advance,

Ruben

 

 

***********************************************************************************************

The information contained in this e-mail is strictly confidential, some or all
of which may be legally privileged. It is for the intended recipient only.
Access to this e-mail by any other person is prohibited. If you are not the
intended recipient, any use, disclosure, copying, printing, distribution of,
replying to or any action taken or omitted to be taken in reliance on this
e-mail, is prohibited and may be unlawful. Please contact the sender immediately
should this e-mail have been incorrectly addressed or transmitted.

You accept that any instructions are deemed to have been given at the time the
recipient(s) accesses them and that delivery receipt does not constitute
acknowledgement or receipt by the intended recipient(s). You accept that there
may be a delay in processing the instructions received from e-mails after
Charles Stanley has received them. You are advised that urgent, time sensitive
and confidential communications should not be sent by e-mail. 

You acknowledge that e-mails are not secure and you accept the risk of
malfunction, viruses, unauthorised interference, mis-delivery or delay.
************************************************************************************************


Charles Stanley & Co. Ltd
Registered Office: 25 Luke Street London EC2A 4AR

Tel: 0207 739 8200 Fax: 0207 739 7798
Registered in England No. 1903304

Charles Stanley Sutherlands and Tozer Wingate are divisions of Charles Stanley & Co. Ltd

Authorised and Regulated by the Financial Services Authority, Member of the
London Stock Exchange, International Securities Markets Association, and The London International Financial Futures &
Options Exchange.

This footnote also confirms that this email message has been swept by McAfee
VirusScan and SurfControl Email Filter software.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20051215/a8acfc5e/attachment-0001.html