[cisco-voip] config p2p on my voice gw

[Kevin Thorngren]

Still not sure what type of card you have.  Try using "show inventory"  
to get the part number.  If you have WIC-1DSU-T1 then take a look at  
this web page and use the service-module command:
http://www.cisco.com/en/US/products/hw/modules/ps3129/ 
products_tech_note09186a00800b1501.shtml

If you have something like the WIC-2T or WIC-1T then you will need an  
external CSU/DSU and a V.35 cable.  You will then configure the CSU/DSU  
with the Line Coding and Framing.
http://www.cisco.com/en/US/products/hw/routers/ps274/ 
products_tech_note09186a00800b0858.shtml

HTH,
Kevin

On Dec 28, 2005, at 1:38 PM, James Grace wrote:

> On my gw im trying to config the line code and framing    with ser-  
> mod  XXXX
> But they wont show up under the serial int.  Im trying a add the cmd  
> under the serial interface.  Because this is not a VWIC card.  Can  
> someone tell me what am I missing
>  
> James D. Grace
> CCNP CCNA MCSE MCDBA
> Sr. System Engineer / Professional Svc.
> Digitel Corporation
>  
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: text/enriched
Size: 1800 bytes
Desc: not available
Url : https://puck.nether.net/pipermail/cisco-voip/attachments/20051228/1379ca29/attachment.bin