[cisco-voip] config p2p on my voice gw

Wed Dec 28 17:00:14 EST 2005

The commands won't show up in the config if the
default options are used which is probably the case if
you're in the US and are using all 24 channels. 

A 'show service-module' will tell you details on how
it is currently running and give framing, lining,
clocking, clock speed, errors if any, alarms if any,
etc. 

--- Kevin Thorngren <kthorngr at cisco.com> wrote:

> Still not sure what type of card you have.  Try
> using "show inventory"  
> to get the part number.  If you have WIC-1DSU-T1
> then take a look at  
> this web page and use the service-module command:
>
http://www.cisco.com/en/US/products/hw/modules/ps3129/
> 
> products_tech_note09186a00800b1501.shtml
> 
> If you have something like the WIC-2T or WIC-1T then
> you will need an  
> external CSU/DSU and a V.35 cable.  You will then
> configure the CSU/DSU  
> with the Line Coding and Framing.
>
http://www.cisco.com/en/US/products/hw/routers/ps274/
> 
> products_tech_note09186a00800b0858.shtml
> 
> HTH,
> Kevin
> 
> On Dec 28, 2005, at 1:38 PM, James Grace wrote:
> 
> > On my gw im trying to config the line code and
> framingï¿½ï¿½ï¿½ with ser-  
> > modï¿½ XXXX
> > But they wont show up under the serial int.ï¿½ Im
> trying a add the cmd  
> > under the serial interface.ï¿½ Because this is not
a
> VWIC card.ï¿½ Can  
> > someone tell me what am I missing
> > ï¿½
> > James D. Grace
> > CCNP CCNA MCSE MCDBA
> > Sr. System Engineer / Professional Svc.
> > Digitel Corporation
> > ï¿½
> > _______________________________________________
> > cisco-voip mailing list
> > cisco-voip at puck.nether.net
> >
> https://puck.nether.net/mailman/listinfo/cisco-voip
> > _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
> 

__________________________________________ 
Yahoo! DSL – Something to write home about. 
Just $16.99/mo. or less. 
dsl.yahoo.com 