[cisco-voip] Caller ID on MGCP FXS Port

[Walenta, Phil]

I don't remember the ICS supporting any sort of caller ID off of its
ports.  

If you can get your hands on an ATA or other gateway, you could test
with those. 

I'd also recommend getting of the ICS entirely (due to end of sale etc),
I've never had good luck getting that platform to do much of anything.

-----Original Message-----
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Court Schuett
Sent: Tuesday, February 08, 2005 2:38 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] Caller ID on MGCP FXS Port 

Hello,

I've got a Gold Fax fax server set up to run off of 4 FXS ports on an
ICS. I have two small hunt groups set up to handle the inbound calls but
I'm having trouble passing the caller id information into the fax lines.

What I would like to do is this:
HP: 7060 -> hunt group that routes to FaxModem1 on server and passes a
predetermined number (it can really be anything) to the fax server.
HP: 7050 -> hunt group that routes to FaxModem2-4 on server and passes a
different predetermined number.

I have almost everything set up. I have both hunt groups set up and
working correctly. 7060 is ringing to the correct modem, and 7050 is
ringing to all three modems (longest idle) correctly. The only problem
is that I can't seem to pass any sort of caller id to the FXS ports.
I've hooked up a regular analog phone and it's not getting anything
either. The CCM is connected to the FXS ports with MGCP.

CCM: 4.0(1)sr2a
HW: ICS7750-MRP300 (MPC860P)
SW: 12.3(2)XA

Any ideas?

Thanks.

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip