[cisco-voip] CCM Analog MGCP Gateway port config LS/GS question

[Andrew Dignan]

That is the only way to do it from CallManager.  If however, you are only
doing it for testing you can just do it using the CLI on the voice gateway
and do a shut no shut.  As long as you do not reset the gateway from CM,
it will not get the new config from TFTP and you can test LS/GS.

Andy - Berbee

> Does anyone know if there is a way to change a Analog
> port signal type from groundstart to loopstart or vice
> versa without rebuilding the whole gateway port in
> ccm?
>
> Have to remove ports from route group, then delete
> them, then add them back, reconfigure them, then add
> back to route group.
>
>
>
>
>
> __________________________________
> Do you Yahoo!?
> Yahoo! Mail - Find what you need with new enhanced search.
> http://info.mail.yahoo.com/mail_250
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>