[cisco-voip] CCM Analog MGCP Gateway port config LS/GS question

[Erick B.]

Yea. I did the router trick earlier, and got through
redoing the 10 FXO ports, route groups on the CCM side
and verifying cfg was all good. Took about 45 mins
with testing afterwards. It could have been a 3 minute
job though if you could change signal type. But
normally this is something you don't do on a regular
basis.

--- Andrew Dignan <andy at dignans.com> wrote:

> That is the only way to do it from CallManager.  If
> however, you are only
> doing it for testing you can just do it using the
> CLI on the voice gateway
> and do a shut no shut.  As long as you do not reset
> the gateway from CM,
> it will not get the new config from TFTP and you can
> test LS/GS.
> 
> Andy - Berbee
> 
> > Does anyone know if there is a way to change a
> Analog
> > port signal type from groundstart to loopstart or
> vice
> > versa without rebuilding the whole gateway port in
> > ccm?
> >
> > Have to remove ports from route group, then delete
> > them, then add them back, reconfigure them, then
> add
> > back to route group.
> >
> >
> >
> >
> >
> > __________________________________
> > Do you Yahoo!?
> > Yahoo! Mail - Find what you need with new enhanced
> search.
> > http://info.mail.yahoo.com/mail_250
> > _______________________________________________
> > cisco-voip mailing list
> > cisco-voip at puck.nether.net
> >
> https://puck.nether.net/mailman/listinfo/cisco-voip
> >
> 
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
> 



		
__________________________________ 
Do you Yahoo!? 
Yahoo! Mail - 250MB free storage. Do more. Manage less. 
http://info.mail.yahoo.com/mail_250