[cisco-voip] H323 Sample config

[Carter, Bill]

This is for a Cisco 1760 with a VIC2-4FXO.

voice call carrier capacity active
voice rtp send-recv
!
!
voice class codec 1
 codec preference 1 g729r8
 codec preference 2 g711ulaw
!
!
!
voice class h323 1
 h225 timeout tcp establish 3 
 
interface FastEthernet0/0.2
 description VoiceVlan
 encapsulation dot1Q 2
 ip address 10.XXX.0.1 255.255.0.0
 h323-gateway voip interface
 h323-gateway voip bind srcaddr 10.XXX.0.1

voice-port 2/0
 signal groundStart
 timing hookflash-out 50
 connection plar 5060
 caller-id enable

dial-peer voice 1 VoIP  (VoIP Peer to CallManager)
 preference 1
 destination-pattern 5060
 voice-class codec 1
 voice-class h323 1
 session target ipv4:10.ZZ.0.10
 dtmf-relay h245-alphanumeric
 fax-relay ecm disable
 fax rate 14400
 no vad
!
dial-peer voice 10 VoIP  (VoIP Peer to SRST Router)
 preference 2
 destination-pattern 5060
 voice-class codec 1
 voice-class h323 1
 session target ipv4:10.XXX.0.2
 dtmf-relay h245-alphanumeric
 fax-relay ecm disable
 fax rate 14400
 no vad
!
dial-peer voice 20 pots
 preference 9
 destination-pattern 9.T
 port 2/0
 


________________________________

	From: Jevin Kasselman [mailto:jkassel at weci.net] 
	Sent: Tuesday, February 22, 2005 7:20 AM
	To: cisco-voip at puck.nether.net
	Subject: [cisco-voip] H323 Sample config
	
	

	Greetings,

	 

	I am trying to find some h323 configs using fxo ports and
callmanager without much luck.  I am needing to direct all incoming
calls to a specific dn.  Does anybody have anything they would be
willing to share or can point me in the right direction on cisco?

	 

	Thanks,

	 

	Jevin

	
	
	
______________________________________________________________________
	O IOL aumentou a caixa de correio para 100 MB!
	Saiba mais <http://www.iol.pt/correio/rodape.php?dst=0501181>