[cisco-voip] SRST Question

[Erick Bergquist]

Wes,

I will have to look/test again. I did not capture them
and the 3 test calls I did had the outbound call with
normal clearing for the VM #. 

Thanks.

--- Wes Sisk <wsisk at cisco.com> wrote:

> Most likely the carrier gave up on the original
> incoming call.  do the 
> debugs for the original incoming call setup show a
> failure with cause 
> code "recovery on timer expire"?
> 
> /Wes
> 
> Erick B. wrote:
> 
> >Hi,
> >
> >I am wondering if there is a timer I can set to get
> a
> >call forward to a PSTN Number to work after a IP
> Phone
> >in fallback rings 4-5 times but does not answer. 
> >
> >If the phone is in use, the forward to the external
> >PSTN # works fine since there is no delay. 
> >
> >But when phone is not in use, call comes in PRI to
> >main # and when in fallback goes to a IP phone and
> it
> >rings 4 or 5 times then it forwards to PSTN # for
> head
> >end location VM and I see the outbound ISDN call
> setup
> >then I hear a busy signal. Cause code is normal
> call
> >clearing. 
> >
> >Any ideas?
> >
> >Also, is there a easy way to for a router in
> fallback
> >to forward calls to a # and go into a VM box for
> this
> >site without having a DID allocated at the head
> end?
> >
> >
> >
> >		
> >__________________________________ 
> >Do you Yahoo!? 
> >Meet the all-new My Yahoo! - Try it today! 
> >http://my.yahoo.com 
> > 
> >
> >_______________________________________________
> >cisco-voip mailing list
> >cisco-voip at puck.nether.net
> >https://puck.nether.net/mailman/listinfo/cisco-voip
> >  
> >
> 



		
__________________________________ 
Do you Yahoo!? 
The all-new My Yahoo! - What will yours do?
http://my.yahoo.com