[cisco-voip] CCM - Leading zeroes on calling number

[Vincent De Keyzer]

Hello,

 

I am facing (maybe because I'm in Europe) a cosmetic issue with CallManager
and a Cisco2821 as gateway.

 

When I receive an incoming call on the gateway, the set-up message appears
as follows:

 

Jan 24 14:45:16.918 CET: ISDN Se0/0/0:15 Q931: RX <- SETUP pd = 8  callref =
0x7194

        Sending Complete

        Bearer Capability i = 0x8090A3

                Standard = CCITT

                Transer Capability = Speech

                Transfer Mode = Circuit

                Transfer Rate = 64 kbit/s

        Channel ID i = 0xA9838A

                Exclusive, Channel 10

        Calling Party Number i = 0x2181, '23334455'

                Plan:ISDN, Type:National

        Called Party Number i = 0xA1, '24447722'

                Plan:ISDN, Type:National

        Sending Complete

 

When the call hits my IP phone, it shows calling number '23334455' instead
of what I had wished, which is '023334455' (since it's a national call).

 

In the same way, for an international call from, say, France, I would
receive on the PRI '33612345678' and 'Type: International', which I would
like to appear on the display of the IP phone as '0033612345678'.

 

How can I add one or two zeros to the calling number based depending on its
type ('National' or 'International')?

 

Vincent

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20050124/69de8290/attachment.html