[cisco-voip] application command on voip dial peer

[Boda György]

Hi,

 

Yes, you can configure IVR apps on voip dial-peers: http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_feature_guide_chapter09186a00802d23d1.html#wp2188467

 

I would use the #incoming called-number xxxx - command for catching incoming calls by the dialed number (DNIS) in dial-peer mode.

 

#destination-pattern - is recommended for outbound dialpeer matching.

 

Gyorgy

 

 

  _____  

From: Geoffrey Cauchi [mailto:geoffrey.cauchi at datastream.com.mt] 
Sent: 2005. június 7. 21:48
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] application command on voip dial peer

 

Hi

 

Is it possible to configure the ivr feature on a voip dial peer, on a cisco router?

 

What I would like to setup is the following:

 

dial-peer voice 310 voip

 description Voip Phone

 destination-pattern 456

 voice-class codec 1

 session target ipv4:192.168.245.5

 

Whenever a user will be calling this number, i.e. 456, he will be prompted by an ivr Prompt.  Is that possible?

BTW, the call will be originated from an ip phone not pots.

 

Thanks

Geoff

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20050708/4f4da77e/attachment.html