[cisco-voip] SRST and MGCP Failover

[Walenta, Phil]

You might be missing this crucial line:
 
!
call application alternate DEFAULT
!
 
That's what makes MGCP kick over to the H.323 part of the gateway fully.

________________________________

From: cisco-voip-bounces at puck.nether.net on behalf of Michael L. Windon
Sent: Fri 7/8/2005 8:55 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] SRST and MGCP Failover



Issue: When operating in fallback-mode out bound calls work but incoming calls get reorder tone. I get the message stating that the mgcpapp was unavailable called:XX was route to the default applications but still reorder tone. Any ideas??

 

 

Sample config:

 

 controller T1 2/0

 framing esf

 linecode b8zs

 ds0-group 1 timeslots 1-24 type e&m-wink-start dtmf dnis

.

..

...

interface Loopback0

 description IP for all traffic sourced from this device 

 ip address 200.200.200.1 255.255.255.255

 ip pim sparse-dense-mode

 load-interval 30

 h323-gateway voip bind srcaddr 200.200.200.1

....

ccm-manager fallback-mgcp

ccm-manager redundant-host 10.10.11.3

ccm-manager mgcp

ccm-manager music-on-hold

ccm-manager config server 10.10.11.2  

ccm-manager config

...

...

mgcp

mgcp call-agent 10.10.11.2 service-type mgcp version 0.1

mgcp bind control source-interface Loopback0

mgcp bind media source-interface Loopback0

..

.

 

dial-peer voice 1 voip

destination-pattern 530....

progress_ind setup enable 3

voice-class codec 1

voice-class h323 1

session target ipv4:10.10.11.2

dtmf-relay h245-alphanumeric

ip qos dscp cs4 media

no vad

 

dial-peer voice 7 pots

 application mgcpapp

 destination-pattern [2-8]......

 direct-inward-dial

 port 2/0:2

 

 

 

Sincerely,

Michael L. Windon
"It is possible to store the mind with a million facts and still be entirely uneducated. "
-Alec Bourne