[cisco-voip] Sip trunk question

[Burton, Jason]

I have the following setup  IP phone-->CM4.1(3)->SIP trunk->CME
3.3(w/CUE2.1.2)

 

I can setup calls and hear voice ok, but when the call goes from left to
right I cannot transfer to VM on the CME system, I get reorder tones.
So for fun I thought I would dial the VM pilot number and I still get
reorder tones.  Any help??

 

The dial peer for VM on CME is:

dial-peer voice 1 voip

 description *** VM Pilot ***

 destination-pattern 1900

 session protocol sipv2

 session target ipv4:10.1.1.10

 dtmf-relay sip-notify

 codec g711ulaw

!

Dial peer back to CM4.1(3)

dial-peer voice 3 voip

 destination-pattern 2...

 session protocol sipv2

 session target ipv4:10.3.1.10

 dtmf-relay sip-notify

 codec g711ulaw

 

Then under CM I have a Sip trunk pointing to the CME gateway and a route
pattern that routes 1XXX to the Sip trunk.

 

Thanks in advance!!

 

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20050726/2633ce2c/attachment.html