[cisco-voip] Can you adjust firmware default volume level on 7912

[Ken McCutcheon]

Morning,
 
I'm looking for a way to adjust the default volume level on the 7912 due
to noise issues.
 
Everytime we do system maintenance and the phones reset, the volume gets
reset to 50% which is too loud for our Health & Safety officer.
 
Is there any tools to adjust the system default?
 
Any help appreciated,
Cheers
 

Ken McCutcheon BInfSc 
Systems Engineer

________________________________________________
Computerland New Zealand
Level 3, 154 Featherson St      Ph: +64 4 439 1241
P.O. Box 3351                          Fax: +64 4 460 6001
Wellington                                Mobile: + 64 275 325 712
ken.mccutcheon at computerland.co.nz
<mailto:ken.mccutcheon at computerland.co.nz> 

http://www.computerland.co.nz <blocked::http://www.computerland.co.nz/> 

CAUTION: This e-mail message and accompanying data may contain
information that is confidential and subject to privilege. If you are
not the intended recipient, you are notified that any use,
dissemination, distribution or copying of this message or data is
prohibited. If you have received this e-mail in error, please notify the
sender immediately and delete all material pertaining to this e-mail.
Computerland New Zealand will not accept liability for any loss or
damage caused by using any material or attachments contained in this
message. While every best practice has been taken, no warranty is made
that this material is free from computer virus or other defect.
Computerland New Zealand's entire liability will be limited to
resupplying the material.

 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20050515/3d346444/attachment.html