[cisco-voip] Adding new Phone in CM 4.1.3

[Voll, Scott]

I deleted the phone from CM and it auto registered.  So I need ES5 to
fix this issue in the future?

Do I have to open a TAC case to get it?  Will it be rolled into the next
SR?

Scott

-----Original Message-----
From: Ryan Ratliff [mailto:rratliff at cisco.com] 
Sent: Thursday, May 26, 2005 10:09 AM
To: Voll, Scott
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] Adding new Phone in CM 4.1.3

Any ES on your CM?

Try letting the phone auto-register, then change the DN.  I've seen an 
issue like this that had to do with the phone resetting after getting 
the .cnf.xml when it should have proceeded to download the correct 
load.  If the phone got the new load from xmldefault.cnf.xml then it 
would upgrade successfully.   That customer upgraded to ES5 to fix the 
change notification CFA bug and couldn't get it to break again.

If your phone really isn't getting an IP address then it's probably a 
different issue.  A sniffer trace should verify it.

-Ryan
On May 26, 2005, at 12:49 PM, Voll, Scott wrote:

Has anyone added a new Phone (7940) to a CM 4.1.3 install?

This is the first Phone I've installed since upgrading to 4.1.3 and for
some reason it won't boot.  It gets the right vlan but won't get a DHCP
Address.  Any ideas?  The firmware that came on it is P0030301mfg2

Scott


_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip