[cisco-voip] CCM - weird pilot point problem

[Vincent De Keyzer]

Erick,

yes, it kind of rings once, then goes to fast busy.

The gateway is H.323. There are no errors in its log. It's a 2821 running:
"Cisco IOS Software, 2800 Software (C2800NM-SPSERVICESK9-M), Version
12.3(11)XL1, RELEASE SOFTWARE (fc1)"

CCM is 4.1(2)sr1.

Vincent

> -----Original Message-----
> From: Erick Bergquist [mailto:erickbe at yahoo.com]
> Sent: mardi 6 septembre 2005 14:13
> To: Marcus Lundbom; Vincent De Keyzer; cisco-voip at puck.nether.net
> Subject: RE: [cisco-voip] CCM - weird pilot point problem
> 
> 
> Is the outside call busy right away, or does it ring
> once then go busy, etc?
> 
> I've seen that cause code usually when theres a DSP
> issue, or lack of DSPs at times for calls to complete.
> More DSPs may be needed if the call is changing to
> another codec after initial setup, etc. Is the gateway
> using MGCP? Are there any errors, etc in the normal
> router log entries (non-debug messages)?
> 
> What version IOS, CCM?
> 
> --- Marcus Lundbom <Marcus.Lundbom at addpro.se> wrote:
> 
> > Is there a codec mismatch or XCode-issue?
> > I recall seeing an similar issue under those
> > circumstances.
> >
> > Best regards,
> >
> >
> > /M
> >
> >
> >
> > ________________________________
> >
> > From: cisco-voip-bounces at puck.nether.net
> > [mailto:cisco-voip-bounces at puck.nether.net] On
> > Behalf Of Vincent De
> > Keyzer
> > Sent: Tuesday, September 06, 2005 10:29 AM
> > To: cisco-voip at puck.nether.net
> > Subject: [cisco-voip] CCM - weird pilot point
> > problem
> >
> >
> >
> > Hello,
> >
> >
> >
> > I have a strange problem with a pilot point that I
> > can reach internally
> > but not from the outside.
> >
> >
> >
> > DN 7778 is a pilot point (not a hunt pilot)
> > connected to an IVR system.
> >
> >
> >
> > When I dial 7778, the IVR picks up the call and
> > plays the initial
> > greeting. So far, so good.
> >
> >
> >
> > Then there is a Translation Pattern (used for
> > incoming calls) that maps
> > a range of 10 external numbers to a range of 10
> > internal numbers:
> > 1234777X -> 777X.
> >
> >
> >
> > So when I dial from the outside to number 12347778,
> > I should reach the
> > IVR. But instead I get a fast busy - a "show call
> > history voice" the
> > gateway shows a "no resource" sent back by the CCM.
> >
> >
> > The TP pattern works OK because I can call 12347770
> > (I reach DN 7770).
> >
> >
> >
> > Anyone?
> >
> >
> >
> > Vincent
> 
> 
> __________________________________________________
> Do You Yahoo!?
> Tired of spam?  Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com