[cisco-voip] CCM - weird pilot point problem

[Erick Bergquist]

Is the outside call busy right away, or does it ring
once then go busy, etc?  

I've seen that cause code usually when theres a DSP
issue, or lack of DSPs at times for calls to complete.
More DSPs may be needed if the call is changing to
another codec after initial setup, etc. Is the gateway
using MGCP? Are there any errors, etc in the normal
router log entries (non-debug messages)?

What version IOS, CCM?

--- Marcus Lundbom <Marcus.Lundbom at addpro.se> wrote:

> Is there a codec mismatch or XCode-issue?
> I recall seeing an similar issue under those
> circumstances.
> 
> Best regards,
>  
> 
> /M 
> 
>  
> 
> ________________________________
> 
> From: cisco-voip-bounces at puck.nether.net
> [mailto:cisco-voip-bounces at puck.nether.net] On
> Behalf Of Vincent De
> Keyzer
> Sent: Tuesday, September 06, 2005 10:29 AM
> To: cisco-voip at puck.nether.net
> Subject: [cisco-voip] CCM - weird pilot point
> problem 
> 
> 
> 
> Hello,
> 
>  
> 
> I have a strange problem with a pilot point that I
> can reach internally
> but not from the outside.
> 
>  
> 
> DN 7778 is a pilot point (not a hunt pilot)
> connected to an IVR system.
> 
>  
> 
> When I dial 7778, the IVR picks up the call and
> plays the initial
> greeting. So far, so good.
> 
>  
> 
> Then there is a Translation Pattern (used for
> incoming calls) that maps
> a range of 10 external numbers to a range of 10
> internal numbers:
> 1234777X -> 777X.
> 
>  
> 
> So when I dial from the outside to number 12347778,
> I should reach the
> IVR. But instead I get a fast busy - a "show call
> history voice" the
> gateway shows a "no resource" sent back by the CCM.
> 
> 
> The TP pattern works OK because I can call 12347770
> (I reach DN 7770).
> 
>  
> 
> Anyone?
> 
>  
> 
> Vincent


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com