[cisco-voip] Help with ISDN VIC2-2BRI-NT/TE cable and configuration

[Lawrence E. Bakst]

At 11:14 AM +0200 9/9/05, Harald Klein wrote:
>Hi Lawrence,
>
>>1. First and foremost can I hook my single pair (2 wire, U interface
>>from PacBell) RJ11 into the RJ-45? I really can't tell as all the
>>Cisco doc shows 4 wire connections to an NT1 but the doc for this
>>card claims "build in NT1".
>
>VIC2-2BRI-NT/TE - Two-port ISDN BRI VIC, S/T interface, NT or TE
>it is S/T, not U.

Thanks. i finally figured that out. The NT in the name of the VIC threw me off. I have an NT1 on order.

>
>>
>>2. What kind of config do I need to get this running? Is what follows
>>even close? If I knew I had the cabling right I could focus on the
>>config. I really can't find a good example on the Cisco site, DSL
>>Reports, or the web. If someone has a sample config known to work
>>with BRI voice that would be great.
>>
>look here:
>http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a0080111b16.shtml
>and here:
>http://www.cisco.com/en/US/products/sw/iosswrel/ps5013/products_feature_guide09186a0080080de8.html
>(with samples)
>
>>4. Do I need both the global "isdn switch-type" and the interface
>>"isdn switch-type"?
>
>interface overrides global..
>
>>Best,
>
>much phun, hari
>>
>>leb)
>
>_______________________________________________
>cisco-voip mailing list
>cisco-voip at puck.nether.net
>https://puck.nether.net/mailman/listinfo/cisco-voip