[cisco-voip] Unity MWI port Question

[Simon, Bill]

I agree that this should work, but what we are saying is that enabling more
MWI ports does not do anything.  Unity only seems to use 2 ports max no
matter how many are enabled.

 

> -----Original Message-----
> From: tomlemay at adelphia.net [mailto:tomlemay at adelphia.net] 
> Sent: Tuesday, April 25, 2006 11:29 AM
> To: Simon, Bill
> Cc: 'cisco-voip at puck-nether.net Voip'
> Subject: Re: [cisco-voip] Unity MWI port Question
> 
> I am having a MWI issue which I working on with TAC at the 
> meoment.  We have only one port designated at the moment for 
> MWI dial out notification and about 1400 users.  Some users 
> report that they get their MWI light to turn on but then 
> there is no new message.  Tac said we need to enable more MWI 
> ports just for out bound MWI notification and to do this you 
> go into nity tools under switch interface and click on the 
> ports tab.  then, select MWI and enabled just for the number 
> of ports you want to dial out for MWI notification.  
> 
> Tom
> 
> ---- "Simon wrote: 
> > I'm with you; I've seen this same behavior (only two MWI 
> ports actually
> > used) and our MWI resynchs take about 6-7 hours for our 
> 6000 subscribers.
> > It's really painful, and even if we schedule them to begin 
> at midnight it's
> > still going when some users come in in the morning.
> >  
> > 
> > ---
> > Bill Simon - bills at tns.its.psu.edu - (814) 865-2270
> > http://tns.its.psu.edu/ <http://tns.its.psu.edu/> 
> > 
> > 
> > 
> >  
> > 
> > 
> >   _____  
> > 
> > From: Ed Leatherman [mailto:ealeatherman at gmail.com] 
> > Sent: Tuesday, April 25, 2006 10:32 AM
> > To: cisco-voip at puck-nether.net Voip
> > Subject: [cisco-voip] Unity MWI port Question
> > 
> > 
> > Hello all,
> > 
> > Does anyone know how to make Unity (4.0) use more than 2-3 
> ports for MWI? I
> > have more than 3 ports configured in UTIM for MWI Dialout, 
> but when I do a
> > MWI Resynch it still only uses up to 3 ports.. I'm not sure 
> where else to
> > set this. The reason I ask is my MWI weirded out this 
> morning and I had to
> > force it to resynch and its been going for 2 hours now.. 
> watching it in the
> > part status monitor window and I think new change requests 
> are just getting
> > queued up behind the resynch job. 
> > 
> > Thanks!
> > -- 
> > Ed Leatherman
> > IP Telephony Coordinator
> > West Virginia University
> > Telecommunications and Network Operations 
> > 
>