[cisco-voip] Caller-ID Question

[Ryan Ratliff]

In that case you need the fix for CSCeg80845 "calling name support  
for call manager express using facility IE" which should be in 12.4(9)T.

-Ryan

On Aug 3, 2006, at 2:41 PM, Israel Lang wrote:

Looks like it is a facility message:

Aug  3 14:40:32.499: ISDN Se0/0/0:23 Q931: RX <- FACILITY pd = 8   
callref = 0x00
84
         Facility i =  
0x9F8B0100A117020179020100800F4E45544741494E20494E464F20535
9
                 Protocol Profile =  Networking Extensions
                 0xA117020179020100800F4E45544741494E20494E464F205359
                 Component = Invoke component
                         Invoke Id = 121
                         Operation = CallingName
                                 Name presentation allowed
                                 Name = ********************

On 8/3/06, Ryan Ratliff <rratliff at cisco.com> wrote: You need to find  
out how your telco is providing the calling name.
Is it in a display IE in the Setup message (this should work)?  In a
Facility message (see CSCeg80845)?

-Ryan

On Aug 3, 2006, at 12:28 PM, Ryan Ratliff wrote:

He was referring to CallManager receiving caller name display, not CME.

I don't have a CME router to test with but is there a command
available under the serial port for the PRI 'isdn incoming display-
ie'?  I know the command will be there for outgoing calls.

I can't say what specific types of inbound calling name display CME
supports.  There are a few different ways the telco can send it.

-Ryan

On Aug 3, 2006, at 12:18 PM, Israel Lang wrote:

I see the caller-id coming in, but not on the phone. My guess is CME
doesn't use MGCP and that is the problem. Any seconds to that notion?

On 8/3/06, Adam Blomfield < adman at adman.net> wrote: It is possible to
get calling name information over a PRI however to
achieve this you must be using the NI2 ISDN protocol on the trunk and
it must be connected to CallManager through an MGCP gateway. Any other
ISDN protocols or an H.323 gateway will not work. You may see the name
information in an q931 debug but it will not be passed to the phone.

On 8/3/06, Israel Lang < zephy316 at gmail.com > wrote:
 > I have a CME 4 system w/ a PRI to the telco. I fail to recall if I
can get
 > caller-id over the PRI. I know I can get the calling number
displayed, but
 > my question is can I get calling name displayed on incoming calls?
 >
 >  Thanks.
 >
 > --
 > Have a great day!!!!!!!!!!
 > zephy316_gmail.com
 >
 > Replace the _ with an @ symbol
 > _______________________________________________
 > cisco-voip mailing list
 > cisco-voip at puck.nether.net
 > https://puck.nether.net/mailman/listinfo/cisco-voip
 >
 >
 >



--
Have a great day!!!!!!!!!!
zephy316_gmail.com

Replace the _ with an @ symbol
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip




-- 
Have a great day!!!!!!!!!!
zephy316_gmail.com

Replace the _ with an @ symbol